Skip to content

Post-installation setup

This document contains extra steps to perform after installing Dasharo in order to enable full functionality.


This section covers Linux post-install steps tested on Ubuntu 22.04. It is likely that similar procedures would for others Linux distributions as well.

Cards using ath10k_pci driver report a firmware failure at module load

If you experience ath10k_pci failing to load with error in dmesg similar to:

[   11.098547] ath10k_pci 0000:07:00.0: wmi unified ready event not received
[   11.148567] ath10k_pci 0000:07:00.0: device has crashed during init
[   11.176535] ath10k_pci 0000:07:00.0: device has crashed during init
[   11.176539] ath10k_pci 0000:07:00.0: failed to wait for target init: -70
[   11.177684] ath10k_pci 0000:07:00.0: could not init core (-110)
[   11.177711] ath10k_pci 0000:07:00.0: could not probe fw (-110)

follow (Firmware Fix section) to fix the problem.