Skip to content

Dasharo Compatibility: OPNsense support

Test cases common documentation

Test setup

  1. Proceed with the Generic test setup: firmware.

OPN001.001 OPNsense stable (serial output) installation on Hard Disk

Test description

This test aims to verify that OPNsense stable (serial output) could be installed on the hard disk on the DUT.

Test configuration data

  1. FIRMWARE = Dasharo
  2. OPERATING_SYSTEM = OPNsense stable

Test setup

  1. Proceed with the Test cases common documentation section.

Test steps

  1. According to the Documentation perform the OS installation process.

Expected result

The information about successful installation should be displayed.

OPN001.002 Boot OPNsense stable (serial output) from Hard Disk

Test description

This test aims to verify that OPNsense stable serial could be booted from the hard disk on the DUT.

Test configuration data

  1. FIRMWARE = Dasharo
  2. OPERATING_SYSTEM = OPNsense stable

Test setup

  1. Proceed with the Test cases common documentation section.

Test steps

  1. Power on the DUT.
  2. Press BOOT_MENU_KEY to enter the boot menu.
  3. In the Boot Menu, select the device on which the system was previously installed.
  4. Wait for the OPERATING_SYSTEM to boot and note the result.

Expected result

The OPERATING_SYSTEM login screen should be displayed.

OPN002.001 OPNsense stable (VGA output) installation on Hard Disk

Test description

This test aims to verify that OPNsense stable (VGA output) could be installed on the hard disk on the DUT.

Test configuration data

  1. FIRMWARE = Dasharo
  2. OPERATING_SYSTEM = OPNsense stable

Test setup

  1. Proceed with the Test cases common documentation section.

Test steps

  1. According to the Documentation perform the OS installation process.

Expected result

The information about successful installation should be displayed.

OPN002.002 Boot OPNsense stable (VGA output) from Hard Disk

Test description

This test aims to verify that OPNsense stable (VGA output) could be booted from the hard disk on the DUT.

Test configuration data

  1. FIRMWARE = Dasharo
  2. OPERATING_SYSTEM = OPNsense stable

Test setup

  1. Proceed with the Test cases common documentation section.

Test steps

  1. Power on the DUT.
  2. Press BOOT_MENU_KEY to enter the boot menu.
  3. In the Boot Menu, select the device on which the system was previously installed.
  4. Wait for the OPERATING_SYSTEM to boot and note the result.

Expected result

The OPERATING_SYSTEM login screen should be displayed.