Hardware configuration matrix
This document describes the hardware configurations used for validation of the coreboot port on ASUS KGPE-D16 platforms.
ASUS KGPE-D16 8MB
| Component | Description |
|---|---|
| Board revision | 1.03G |
| CPU | AMD Opteron(TM) Processor 6282 SE |
| CPU Cooler | |
| RAM | DDR3 16GB Kingston KVR16R11D4/16 |
| Flash memory | Winbond W25Q64FV 8MB |
| Network | Local network wired connection |
| Attached devices | 1. Goodram 16GB USB stick |
| 2. ASUS TPM-L R2.0 module (chip Infineon SLB9665 TT2.0) | |
| Power Supply | 700 W ATX type power supply |
| Power Control | 1. Sonoff S20 switch |
| 2. Goldpin cables (RTE <-> Board connection) | |
| Remote Testing Environment | 1. RTE v1.0.0 (firmware v0.5.3) connected via RS232 |
| 2. Goldpin cables + qspimux (RTE <-> flash memory connection) | |
| TPM | Infineon SLB9665 TT2.0 |
Standard testing procedure is performed on setup without TPM module.
ASUS KGPE-D16 16MB
| Component | Description |
|---|---|
| Board revision | 1.03G |
| CPU | AMD Opteron(TM) Processor 6282 SE |
| CPU Cooler | |
| RAM | DDR3 16GB Kingston KVR16R11D4/16 |
| Flash memory | Winbond W25Q128JV 16MB |
| Network | Local network wired connection |
| Attached devices: | 1. Goodram 16GB USB stick |
| 2. ASUS TPM 1.2 Rev 1.02h module (chip Infineon SLB9635 TT 1.2) | |
| 3. Post Debug Card | |
| Power Supply | 700 W ATX type power supply |
| Power Control: | 1. Sonoff S20 switch |
| 2. Goldpin cables (RTE <-> Board connection) | |
| Remote Testing Environment | 1. RTE v1.0.0 (firmware v0.5.3) connected via RS232 |
| 2. POMONA Clip + DIP8/SOIC8 adapter (RTE <-> flash memory connection) | |
| TPM | Infineon SLB9635 TT1.2 |
Standard testing procedure is performed on setup without TPM module.
ASUS KGPE-D16 board ports, slots, and connectors description is available in the manufacturer documentation (page 2-7).